Broadband-Hamnet™ Forum :: Problems & Answers
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Installed wrong version.. 2014-10-02- 02:21:32 
K7BUM
Member
Joined: 2014-02-07- 13:54:01
Posts: 2
Location: 

I have a WRT54G v.2 and mistakenly uploaded the wrong model firmware. Setting it up as a HSMM-Meshnode - I was able to set the nodename - Router rebooted. - Router is visible on the WLAN through its SSID - Router does not issue IP numbers via DHCP (neither wirelessly or through the LAN ports) - I can get into the router into failsafe mode via telnet. - I have Windows 7 computers to work with. Is there a procedure to re-flash the router with the correct image? Thank you in advance- Mike
IP Logged
 Subject :Re:Installed wrong version.. 2014-10-04- 13:22:00 
ZL3GSL
Member
Joined: 2014-04-04- 19:26:09
Posts: 19
Location: Christchurch NZ
Get a tftp program and follow the instructions about using failsafe mode in the startup section. I used tftpd64 on a laptop under W8.1 sucessfully. 73, Graham ZL3GSL
IP Logged
73, Graham ZL3GSL
Page # 


Powered by ccBoard


SPONSORED AD: