Broadband-Hamnet™ Forum :: Hardware
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Will a newer Bullet M2 go below 2.412 Ghz?.. 2015-10-05- 01:44:04 
VE4CY
Member
Joined: 2015-09-28- 09:31:25
Posts: 2
Location: 

I'm looking at picking up a new Bullet M2.  I'm wondering if these can be programmed to work down into the ham band.  2.407 Ghz, 2.402 GHz, 2.397 GHz.

Has anyone done this successfully? 

PS.  I'm aware of the new v5.6xx firmware warning... I'll be careful of that.
IP Logged
 Subject :Re:Will a newer Bullet M2 go below 2.412 Ghz?.. 2015-10-05- 04:20:00 
k5dlq
Member
Joined: 2012-05-11- 08:05:13
Posts: 233
Location: Magnolia, TX USA
 
yes, but, not with BBHN firmware.
IP Logged
Darryl - K5DLQ
www.aredn.org
 Subject :Re:Will a newer Bullet M2 go below 2.412 Ghz?.. 2015-10-05- 04:25:36 
VE4CY
Member
Joined: 2015-09-28- 09:31:25
Posts: 2
Location: 

Thanks for the quick reply!! OK.. So if I can't do it with the BBHN firmware, will it be possible to take part in our local mesh if they use a frequency is 2.402 Ghz?  

IP Logged
Last Edited On: 2015-10-05- 04:28:02 By VE4CY for the Reason
 Subject :Re:Will a newer Bullet M2 go below 2.412 Ghz?.. 2015-10-05- 04:34:41 
k5dlq
Member
Joined: 2012-05-11- 08:05:13
Posts: 233
Location: Magnolia, TX USA
 

email sent.

But, to answer part of you question, YES.  You can use DTD (device-to-device) linking to bridge between BBHN's channel 1 and other channels, like the ham only channel "-2" (2397Mhz), or 3400Mhz, or, 5900Mhz, etc.

It works very well.
IP Logged
Last Edited On: 2015-10-05- 04:51:54 By k5dlq for the Reason
Darryl - K5DLQ
www.aredn.org
Page # 


Powered by ccBoard


SPONSORED AD: