Broadband-Hamnet™ Forum :: Problems & Answers
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Ubiquiti Bullet M2 no route to internet.. 2015-10-17- 08:35:18 
kd8snh
Member
Joined: 2014-12-21- 22:01:04
Posts: 5
Location: 

Hello all, 

Just setup my first node with the 3.1.0 firmware and I'm not able to access the internet from the node.

From the administration page if I click refresh I get an 'error: no route to the internet'. telnet into the ubiquiti and not able to ping any external IP address. i.e. 8.8.8.8 'ping: sendto: Network is unreachable.'.  Mesh Gateway is checked.

The node is connected to my home network 192.168.1.0/24, the nodes LAN Mode is "NAT" IPaddr 192.168.1.20 mask 255.255.255.0 

Currently there are no other nodes in range of my qth, the node is able to see other wifi access points in my area.

Ubiquiti routing table. 

Destination Gateway GenMask Iface

10.0.0.0 * 255.0.0.0 eth0.2

10.0.0.0 * 255.0.0.0 wlan0

192.168.1.0 * 255.255.255.0 eth0
IP Logged
 Subject :Re:Ubiquiti Bullet M2 no route to internet.. 2015-10-17- 09:01:17 
kd8snh
Member
Joined: 2014-12-21- 22:01:04
Posts: 5
Location: 
Nevermind I found it... Needed to add a static route to the wifi address. http://ohiopacket.org/index.php/Integrating_HSMM-MESH_into_an_existing_network
IP Logged
 Subject :Re:Ubiquiti Bullet M2 no route to internet.. 2015-10-17- 09:01:56 
kd8snh
Member
Joined: 2014-12-21- 22:01:04
Posts: 5
Location: 
Nevermind I found it... Needed to add a static route to the wifi address. http://ohiopacket.org/index.php/Integrating_HSMM-MESH_into_an_existing_network
IP Logged
Page # 


Powered by ccBoard


SPONSORED AD: