Broadband-Hamnet™ Forum :: Hardware
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Upgrading problems.. 2014-07-08- 10:46:13 
WF8S
Member
Joined: 2013-11-05- 10:56:59
Posts: 19
Location: 

I just upgraded one of my perfectly running mesh nodes to the newest firmware and upon rebooting is too is now in MESH AP mode with a 172.27.0.1 IP address.

Any ideas?
IP Logged
 Subject :Re:Upgrading problems.. 2014-07-08- 10:52:01 
KG6JEI
Member
Joined: 2013-12-02- 19:52:05
Posts: 516
Location: 

Are you sure it's mesh ap and not default configuration mode?


Upon upgrade the node defaults to  unconfigured
IP Logged
Note: Most posts submitted from iPhone
 Subject :Re:Upgrading problems.. 2014-07-08- 10:59:49 
KF5JIM
Future Astronaut
Joined: 2013-07-17- 12:13:36
Posts: 250
Location: Nederland

I just flashed my node, Conrad. It's the default initial configuration. WF8S, you need to change the node name and password. And upon reboot, it will go into mesh mode
IP Logged
My opinions and views expressed here are solely my own.
 Subject :Re:Upgrading problems.. 2014-07-08- 11:44:25 
WF8S
Member
Joined: 2013-11-05- 10:56:59
Posts: 19
Location: 

Thank you Gentlemen.


After a big bowl of soup beans and cornbread I trird that and it worked.

Been a rough day at work and my patience was running a little thin.

Sorry...
IP Logged
Page # 


Powered by ccBoard


SPONSORED AD: