Broadband-Hamnet™ Forum :: Hardware
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :WRT54G3G-AT.. 2013-07-11- 23:20:36 
F6CNB
Member
Joined: 2013-06-20- 09:22:08
Posts: 17
Location: Frelsburg, Texas

Hey,


I have converted a WRT54G3G-AT (the ATT version) to HSMM-MESH yesterday. The firmware from the HSMM website did not upload on it because the header is for a generic WRT54G3G. The trick was to edit the header at the beginning of the file with an Hex editor. Contact me if you run in the same problem. The principle of the fix should work for all the versions (-AT, -ST, -VN in the US and -EU,-EM in Europe).


The node ( W5-F6CNB-160 ) is setup  and running inside the house in Frelsburg, Texas. The next step will be to find the coax of my 60ft high wifi omni antenna on the tower. It may take a little bit as I'll probably have to climb the tower and I have no plan to do it by 100F (40C) temperature.


73s Remi W5/F6CNB
IP Logged
 Subject :Re:WRT54G3G-AT.. 2013-07-14- 09:11:07 
Joined: 2024-12-22- 04:35:46
Posts: 0
Location: 

Yep. That's the same with the WRT54G3G-ST (Sprint Version):
http://hsmm-mesh.org/hsmm-mesh-forums/view-postlist/forum-2-hardware/topic-257-wrt54g3g-st.html

What is the 4 byte header for the AT&T version?
IP Logged
 Subject :Re:WRT54G3G-AT.. 2013-07-14- 09:41:59 
F6CNB
Member
Joined: 2013-06-20- 09:22:08
Posts: 17
Location: Frelsburg, Texas
I have to replace the first 32 bytes with the one from the latest Linksys firmware. The first 4 bytes are W3GA .
IP Logged
 Subject :Re:WRT54G3G-AT.. 2013-07-14- 11:41:51 
Joined: 2024-12-22- 04:35:46
Posts: 0
Location: 
Thanks! I'll be on the lookout for those too.
IP Logged
 Subject :Re:WRT54G3G-AT.. 2013-08-03- 18:39:41 
K6DPY
Member
Joined: 2012-01-22- 12:54:21
Posts: 18
Location: Los Angeles
Thanks! I also have a WRT54G3G-AT, firmware version 2.02.02, that I'm planning to convert. Good to know it worked for you.
IP Logged
Page # 


Powered by ccBoard


SPONSORED AD: