Hi all, I have a Ubiquiti Bullet M2 that was working fine  and after I selected the access point setting

I can't get back in. so far I have tried a pushing the reset switch under the bullet for 3-7 seconds

and try again to log in with the following http://localnode:8080 and no go,

also try to do a hard reset (more time holding the reset switch like 13-20 seconds)

and still no go. also try to Power off the bullet and hold the reset switch and power back on while holding

the reset switch and after waiting a while for the unit to come on the led lights keep flashing for a while

and then power off and back on and still no go, I think I did a hard reset to all the software but no go still.

can anyone help?

Thanks.

n6toc