Broadband-Hamnet™ Forum :: Problems & Answers
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Router forgot new login?.. 2012-09-12- 10:25:54 
KD4E
Member
Joined: 2012-07-29- 13:39:05
Posts: 55
Location: Nevils in SE-Georgia, USA
 

I have two Linysys WRT54G3G-ST routers with firmware changed to hsmm-mesh.

Both have been previously tested and worked fine and saw each other.

I changed the login & password on each and that info was duly stored on the two laptops.

I was trying to connect a TRENDnet IP camera so I fired them up but cannot get into Setup.

Neither router remembers the new login & password nor do they recognize the default open-wrt login & password.

I was planning to use these for a project that starts tomorrow.

What do I do, please?

Thanks!


PLEASE DISREGARD:  Found this:

http://hsmm-mesh.org/documentation/71-using-safe-mode-to-reset-a-forgotten-password.html
IP Logged
Last Edited On: 2012-09-12- 10:57:00 By KD4E for the Reason
 Subject :Re:Router forgot new login?.. 2013-08-31- 08:15:55 
KD4E
Member
Joined: 2012-07-29- 13:39:05
Posts: 55
Location: Nevils in SE-Georgia, USA
 

I am unable to log into either of my routers. I'm trying to update to Broadband-Hamnet v 1.0 If I use the Console -> telnet 192.168.1.1 method as linked above the computer sees the router fine - but via a browser neither 192.168.1.1 or localhost:8080/ is recognized. Any idea as to why this might be, please?


BTW: Telnet says ad5oo Build 126 Version 0.4.3
IP Logged
Last Edited On: 2013-08-31- 08:30:21 By KD4E for the Reason
 Subject :Router forgot new login?.. 2013-08-31- 16:16:55 
wx5u
Member
Joined: 2013-01-02- 00:30:45
Posts: 188
Location: Austin, TX

Should that be localNODE, not localHOST?

IP Logged
I'm not part of the development team, so take what I say with a grain of salt. I'm also easily confused.

Check out the free Wireless Networking Book
 Subject :Re:Router forgot new login?.. 2013-09-01- 01:14:47 
KD4E
Member
Joined: 2012-07-29- 13:39:05
Posts: 55
Location: Nevils in SE-Georgia, USA
 
Just tried both, no joy. BTW: Wireless sees the IBSS HSSM-MESH device. Then I replugged the cable and eth0 connected using localnode:8080 Weird ... perhaps a bad cable? When I get home from church I'll try the upgrade to BBHN. Thanks!
IP Logged
 Subject :Re:Re:Router forgot new login?.. 2013-09-01- 07:16:53 
wx5u
Member
Joined: 2013-01-02- 00:30:45
Posts: 188
Location: Austin, TX

You're welcome. 

Sometimes the PC remembers some old network information and unplugging and replugging the cable will make it reconfigure itself correctly.   Of course, a bad cable would explain it too.



[KD4E 2013-09-01- 01:14:47]:

Just tried both, no joy. BTW: Wireless sees the IBSS HSSM-MESH device. Then I replugged the cable and eth0 connected using localnode:8080 Weird ... perhaps a bad cable? When I get home from church I'll try the upgrade to BBHN. Thanks!
IP Logged
I'm not part of the development team, so take what I say with a grain of salt. I'm also easily confused.

Check out the free Wireless Networking Book
Page # 


Powered by ccBoard


SPONSORED AD: