Broadband-Hamnet™ Forum :: Firmware
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Messed up my Linksys node... 2014-02-05- 15:50:48 
KK4URZ
Member
Joined: 2013-11-23- 20:24:41
Posts: 23
Location: 

So I was working on my node, and just got a raspberry pi. Trying to get them to connect to each other. However, I think I've messed my  linksys up. I think I put it in mesh gateway mode and for some reason I see two SSIDs now one with the IP of what the node used to be, and the name of the node. I can connect to either of them but get no IP address, and I'm trying from memory to figure out what it is.


Anyway I can reset this thing so I can upload the firmware and start fresh?

IP Logged
 Subject :Re:Messed up my Linksys node... 2014-04-05- 16:03:37 
Kb3lzv
Member
Joined: 2013-06-29- 10:42:02
Posts: 15
Location: Odenton, Maryland
 
Anyway I can reset this thing so I can upload the firmware and start fresh? I have the same question.
IP Logged
When not at work, I am hunting, fishing, or hamming it up!
 Subject :Messed up my Linksys node... 2014-04-06- 14:41:50 
wx5u
Member
Joined: 2013-01-02- 00:30:45
Posts: 188
Location: Austin, TX

Some hints here:

http://www.broadband-hamnet.org/documentation/68-firmware-installation-instructions.html

Look for the TFTP section.


http://www.broadband-hamnet.org/documentation/71-using-safe-mode-to-reset-a-forgotten-password.html
IP Logged
I'm not part of the development team, so take what I say with a grain of salt. I'm also easily confused.

Check out the free Wireless Networking Book
Page # 


Powered by ccBoard


SPONSORED AD: