Broadband-Hamnet™ Forum :: UBNT Firmware
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Image upgrade not supported.. 2014-09-02- 17:59:03 
F4AAG
Member
Joined: 2014-09-02- 13:42:05
Posts: 2
Location: 

Thank youthank you for all the information presented on the site because I debuted with Hamnet in the south of France.

I use a nanostation2 with the latest software version Ubiquiti.I can not seem to load the Hsmm by AirOS software file. A message says that the software is invalid.

I tested bbhn-1.1.2 and earlier version. Does anyone have a solution? 

Hello everyone,
IP Logged
 Subject :Re:Image upgrade not supported.. 2014-09-02- 19:09:10 
KG6JEI
Member
Joined: 2013-12-02- 19:52:05
Posts: 516
Location: 

We only support the M series of Ubiquiti gear.

It needs to be a NanoStation M2 
IP Logged
Note: Most posts submitted from iPhone
 Subject :Re:Image upgrade not supported.. 2014-09-03- 09:36:19 
F4AAG
Member
Joined: 2014-09-02- 13:42:05
Posts: 2
Location: 
Sorry, it's a Nanostation M2
IP Logged
 Subject :Re:Image upgrade not supported.. 2014-09-03- 09:41:21 
KG6JEI
Member
Joined: 2013-12-02- 19:52:05
Posts: 516
Location: 
Make sure you downloaded the nano FACTORY image not the sysupgrade image (file will say factory and nano in it's name)
IP Logged
Note: Most posts submitted from iPhone
 Subject :Re:Image upgrade not supported.. 2014-09-05- 14:21:39 
KB5LNC
Member
Joined: 2012-04-09- 20:28:15
Posts: 9
Location: Stafford, VA
 
I am having a similar problem. When flashing from in AirOS I get the following error: "Firmware image check failed. Error code: -6" I am using the factory firmware bin file for the nano. bbhn-1.1.2-ar71xx-generic-ubnt-nano-m-squashfs-factory.bin Any ideas?
IP Logged
 Subject :Re:Image upgrade not supported.. 2014-09-07- 16:56:45 
KG6JEI
Member
Joined: 2013-12-02- 19:52:05
Posts: 516
Location: 

What version of AirOS is currently installed?
IP Logged
Note: Most posts submitted from iPhone
 Subject :Re:Image upgrade not supported.. 2014-09-07- 17:02:56 
KB5LNC
Member
Joined: 2012-04-09- 20:28:15
Posts: 9
Location: Stafford, VA
 

5.5.9 and I believe I have the XW versions...which I don't think is supported.  


I was able to flash two AirGrid M5s with no issues.....
IP Logged
 Subject :Re:Image upgrade not supported.. 2014-09-07- 17:16:20 
KG6JEI
Member
Joined: 2013-12-02- 19:52:05
Posts: 516
Location: 

This is an M5 device I assume unlike the M2 of the OP correct ? (I haven't seen XW outside the M5 line if they are I would like to know)


Yes the XW is not yet supported but it is being worked on in BBHN->ticket:43 
IP Logged
Note: Most posts submitted from iPhone
 Subject :Re:Image upgrade not supported.. 2014-09-07- 17:25:55 
KB5LNC
Member
Joined: 2012-04-09- 20:28:15
Posts: 9
Location: Stafford, VA
 

Correct, an NSM5.....we recently go permission from the county to put sites on their 10 comm towers to create a mesh.  

There is a small group of us working on the 5GHz band.  The county has an event going early October and we are looking to set something up from the site to the EOC.  Probably going to work the 2.4GHz at the site and use the 5GHz to reach back to the EOC for the event.   Going to try and work a "roving" IP can to test out the local mesh at the site/event.  We are looking to get on the hangar and put a temp antenna up to get some elevation and reach back to the county EOC.
IP Logged
Page # 


Powered by ccBoard


SPONSORED AD: