Broadband-Hamnet™ Forum :: Problems & Answers
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :WRT-300N V1.1 Bricked??.. 2012-10-08- 05:28:53 
ve3kr
Member
Joined: 2012-10-05- 09:18:16
Posts: 4
Location: 

Hi this is my first attempt at making a mesh node and have run into trouble. I had DDWRT on the router and flashed it to the hsmm-mesh-0.4.3wrt300n_v1.bin and I have lost connectivity with the lan ports to my pc. Also all the front lights are now lit up steady. The router is a WRT-300N v1.1

Is there a way out of this?
IP Logged
 Subject :Re:WRT-300N V1.1 Bricked??.. 2012-10-08- 17:46:10 
KY9K
Member
Joined: 2012-07-07- 23:39:07
Posts: 23
Location: Roy, WA
There is some info on the device in the OpenWRT wiki: http://wiki.openwrt.org/oldwiki/OpenWrtDocs/Hardware/Linksys/WRT300N If holding the rest button for 10-15 seconds while applying power to the router doesn't get it booting up, you may have to go the serial console route to see what may be happening in RedBoot. I see an ID of the connector location in the wiki page, but the pinout listing doesn't specify if it is relative to pin1. Might need to probe to identify at least VCC and GND to be sure. The port is at TTL levels so you'll need an adapter cable. 73-KY9K/Brian
IP Logged
 Subject :WRT-300N V1.1 Bricked??.. 2013-12-13- 21:53:55 
wx5u
Member
Joined: 2013-01-02- 00:30:45
Posts: 188
Location: Austin, TX

I know this is an old thread, but in case someone else searches and ends up here:

The WRT-300N v.1.1 and higher versions use significantly different hardware vs. WRT-300Nv1.  Since the firmware makes a point of saying "v1," don't assume it will work for a WRT-300Nv1.1.

http://wiki.openwrt.org/toh/linksys/wrt300n1
IP Logged
I'm not part of the development team, so take what I say with a grain of salt. I'm also easily confused.

Check out the free Wireless Networking Book
Page # 


Powered by ccBoard


SPONSORED AD: