Broadband-Hamnet™ Forum :: Problems & Answers
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :irc (20.2) and new V1 of Broadband-HAMNET.. 2013-08-05- 06:21:11 
N4TTY
Member
Joined: 2013-03-15- 09:05:17
Posts: 31
Location: Stone Mountain, GA

Just upgraded my mesh nodes to the V1 Broadband-HAMNET.  All seems to have gone without a hitch.  Great job guys!!

My current issue is when installing the 20.2 version of irc, under 'Port Forwarding' when 'POPPING HOLES IN THE FIREWALL' I don't get a choice of 'WiFi' in the pulldown for 'Interface', just WAN.  No 'WiFi' to select.

Any ideas?

Steve G./N4TTY
IP Logged
 Subject :Re:irc (20.2) and new V1 of Broadband-HAMNET.. 2013-08-05- 10:28:40 
ae5ae
Member
Joined: 2010-10-27- 00:47:17
Posts: 144
Location: Van Alstyne, TX

Steve,

    I put that message into the install script before I found out that the default mode was going to be DMZ/Direct mode.  It's still correct for NAT mode. :-)  Consequently, in v1.0.0 with the default DMZ mode, there is no firewall between the node and the wifi interface so poking a hole in the firewall is not necessary in that mode.  All you can do now is just advertise the service if you want.

-Rusty-
IP Logged
 Subject :Re:irc (20.2) and new V1 of Broadband-HAMNET.. 2013-08-07- 04:58:41 
N4TTY
Member
Joined: 2013-03-15- 09:05:17
Posts: 31
Location: Stone Mountain, GA
Thanks Rusty! It is working, so that is what I was after!! Steve G./N4TTY
IP Logged
Page # 


Powered by ccBoard


SPONSORED AD: