Broadband-Hamnet™ Forum :: VoIP
Board Index Latest Posts Welcome Guest   [Register]  [Login]
 Subject :Using the Linksys SPA1001 for Raspberry-Asterisk PBX.. 2013-08-18- 05:40:12 
KI4WPI
Member
Joined: 2012-09-16- 04:20:26
Posts: 19
Location: Tamarac, FL

I finally figure it out and have two Linksys SPA1001 fully working and very well through the Raspberry-Asterisk PBX server.  These modules are great for hooking up to a fax machine through VoIP or using any landline phone into the mesh..  

Setup was easy, these instructions were on the spot for this:
http://www.voiptuto.com/?q=en/spa1001

One other note: You have to enable all nodes (check the box) for "Gateway Mesh" in "Basic Setup" for a remote node to connect it's VoIP phone to the PBX Mesh node.. 

KI5JIM's video tutorial on this site was also useful for first time installers, just need to adjust accordingly for different VoIP devices...

Gary  KI4WPI
IP Logged
Gary Michalosky
KI4WPI
 Subject :Re:Using the Linksys SPA1001 for Raspberry-Asterisk PBX.. 2013-08-18- 20:49:15 
SM7I
Member
Joined: 2012-04-30- 14:56:55
Posts: 79
Location: JO65mo
 

Hi Gary, It´s not needed to enable "Gateway Mesh" on all the nodes since the phones will find their route through the mesh anyway and register with the PBX.


My setup is using an rPi Asterisk PBX connected to the LAN side of my node that also acts as "Gateway Mesh" and then I have a couple of Cisco phones connected to subsequent nodes in the mesh, on respective LAN side, which works just fine.
IP Logged
Last Edited On: 2013-08-18- 20:49:45 By SM7I for the Reason
IT infrastructure and security professional
 Subject :Re:Using the Linksys SPA1001 for Raspberry-Asterisk PBX.. 2013-08-20- 11:55:10 
KI4WPI
Member
Joined: 2012-09-16- 04:20:26
Posts: 19
Location: Tamarac, FL
Thanks for the advice! I ran out of days off last week and had to go back to work to support this habit!! I plan to get back into it Thursday and will adjust the Gateway Mesh settings as you advise. I don't remember if I did enable it on the node that the Asterisk server is on currently and could be why it wasn't handshaking with the other node initially.. Gary- KI4WPI
IP Logged
Gary Michalosky
KI4WPI
 Subject :Re:Using the Linksys SPA1001 for Raspberry-Asterisk PBX.. 2013-10-21- 13:40:49 
KI6WDY
Member
Joined: 2013-07-15- 13:27:16
Posts: 14
Location: 
Not getting a dial tone (?)
IP Logged
 Subject :Re:Using the Linksys SPA1001 for Raspberry-Asterisk PBX.. 2013-11-02- 18:29:43 
KI6WDY
Member
Joined: 2013-07-15- 13:27:16
Posts: 14
Location: 

Got one now
IP Logged
Page # 


Powered by ccBoard


SPONSORED AD: