After updating with file for existing firmware, not able to log in with (used to be working login/password)

tried several that upload instructions mention, but no luck so far.  Appears the update was accepted, but made where not able to log in with original password, or default password..

thanks.

The node should revert to all default after loading (root/hsmm) and will be avaliable at http://localnode:8080/

You should be able to see the status page showing 1.1.0 as well.

if not chdxk to make sure your PC has obtained a new dhcp lease after uploading the firmware (the node will revert to initial configuration mode )

2nd node

update appears to take effect, but (root/hssm) or original (login/pw) no work, this is 2nd node have tried so far..   same thing..

#1 was a WRT54GL

#2 was a WRT54GS

Once update is applied, get redirected to device, but no login / password that I have tried so far appears to be working..

These were working nodes and applied the update,  top of software download list for Linksys working nodes..  All appeared to be working and normal, before applying update..

Thanks.

Well naturally it was an operator error,   and I apologize for posting..    I was using hssm instead of hsmm

Appears to be working now..   sometimes the smallest of errors make a BIG difference..

All OK at present

Yes, I have 7 nodes upgraded to 1.1.0 and all appear to be working normally..

amazing what little bitty details can make happen, or NOT..