Anyone here running Asterisk on a Bullet?  Asterisk appears to be running; my Cisco IP phones grab the time and date from the NIST server via a Linksys node but I can't see the actual extension and calls do not place.

I've gone through the Linksys instructions a few times and suspect I'm missing something obvious to an experienced hand.

One potential:  must I still configure port forwarding on BBHN as was necessary on HSMM-Mesh?  I've taken a stab at port forwarding via the GUI but it didn't do anything in my case.

I also need ubiquiti help, 

I've got a UBNT v3.1 bullet together with a cisco 7940 and a pi running asterisks connected with a switch;   trying to connect across the mesh to another bullet/cisco 7940.  As far as I can figure, I've followed the videos exactly,  The mesh is up, the pi is running asterisks, Freepbx shows that its running (except for the phones).  I've set up the config files and phones per the video and the phones seem to be talking/downloading something, but all I ever get, on either phone, is: " phones unprovisioned ".

There is the question of the time base, as the pi thinks its in the 1900's.  Even with bad time, i figured that at least the phones would pick up the configuration.

Are there any cisco firmware concerns? 

Also, I'm wondering if the switch is the right way to combine the pi, phone and UBNT (bullet has only one port).  The bullet seems to be doing the dhcp ok. Maybe disable the dhcp on the bullet and put another router in the middle?

Any thoughts would be greatly appreciated.